Bronze Pope For Australia Customer

Product introduction

We have made the bronze pope statue John Paul II for our Australia customer. The height of pope is 2.5m. Now the bronze pope was placed in a church.
We spent a lot of time doing the clay model. First, we checked out a lot data to study his tie. His tie is not tied to the clothes, but When he dressed and then took the tie.
Then the small flowers on the clothes are also need carved carefully. Beside, the ribbon also spend lot of time, because pope’s ribbon have several modeling.
At first , we have done a cloth for his ribbon. When communicated to our customer, he requests two ribbons. Then we revised the ribbon according the customer’s request and made octagon base for the pope.
When the bronze pope statue’s clay model was completed, he and his mother came to our factory to check the clay model.The following is the clay model.

When our customer confirmed the clay model, we began to cast.

The following photo is the final photo. When our customer received the pope, he is very satisfied.

And he sent us a good feedback email to express his satisfaction and gratitude to us and our masters.